Clarke 3120181 운영 및 유지 관리 지침 - 페이지 11

{카테고리_이름} Clarke 3120181에 대한 운영 및 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke 3120181 17 페이지. Sabre saw

페이지 인쇄

TROUBLESHOOTING

SYMPTOM

Tool runs at normal

speed but slows down

under any load.

Tool runs slowly. Air flows

weakly from exhaust.

Tool will not run. Air flows

freely from exhaust.

Tool will not shut off.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]

PROBLEM

1. Excessive pressure on

drill.

2. Motor parts worn.

3. Worn or sticking

mechanism due to

lack of lubricant.

1. Motor parts jammed

with gum/dirt.

2. Regulator in closed

position.

3. General airflow

blocked by dirt.

1. Motor vanes stuck

due to buildup of

foreign material.

1. O-rings damaged or

ill-fitting in seat.

SOLUTION

1. Reduce the force

applied to the drill.

2. Return to Clarke dealer

for repair.

3. Drip air tool lubricating

oil into air inlet. Allow oil

to soak moving parts

before using.

1. Examine inlet air filter for

cleanliness.

2. Adjust regulator to open

position.

3. Operate tool in short

bursts.

1. Disconnect air supply

and rotate tool assembly

manually.

2. Try operating tool in

short bursts.

3. Tap motor housing gently

with a rubber mallet.

4. Drip a few drops of air

tool lubricating oil into air

inlet to soak moving

parts.

1. Return to Clarke dealer

for repair.