Clarke 6470162 운영 및 유지보수 지침 매뉴얼 - 페이지 5

{카테고리_이름} Clarke 6470162에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke 6470162 17 페이지. 355mm abrasive cut-off saw

e. Store idle power tools out of the reach of children and do not allow

persons unfamiliar with the power tool or these instructions to operate

the tool. Power tools are dangerous in the hands of untrained users.

f. Keep cutting tools sharp and clean. Properly maintained cutting tools

with sharp cutting edges are less likely to bind and are easier to control.

g. Use the power tool, accessories and tool bits etc. in accordance with

these instructions, taking into account the working conditions and the

work to be performed. Use of the power tool for operations different

from those intended could result in a hazardous situation.

SERVICING

a. Have your power tool serviced by a qualified repair person using only

identical replacement parts. This will ensure that the safety of the power

tool is maintained.

ADDITIONAL WARNINGS FOR CUT-OFF SAWS

1. IMPORTANT: You should not operate this machine unless you are thoroughly

familiar with metal cutting saws. If there is any doubt whatsoever, you

should consult a qualified person.

2. DO NOT operate the machine until it is completely assembled and this

entire manual has been read and understood.

3. Ensure the proper electrical regulations are followed.

4. Ensure the abrasive disc is securely mounted in accordance with these

instructions before connecting to a power supply.

5. DO NOT over tighten the abrasive disc. This can cause stress, and could

lead to the wheel shattering when under load.

6. ALWAYS check the abrasive disc for cracks before use.

7. Before switching the machine on, ALWAYS ensure the work is properly

secured. ALWAYS use the vice, NEVER hand hold a workpiece.

8. Make all adjustments with the power OFF.

9. When starting a cut, always ease the tool into the workpiece. A harsh or

sudden impact could shatter the abrasive disc.

10. Ensure the abrasive disc reaches maximum speed before beginning a cut.

11. NEVER use the machine with the guards removed.

12. Ensure you use the correct type of abrasive disc for the type of material

being cut. Metal cutting & masonry abrasive discs are available from your

CLARKE dealer. NEVER cut magnesium, wood, or non-ferrous metals.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]