Clarke 6470168 운영 및 유지보수 지침 매뉴얼 - 페이지 5
{카테고리_이름} Clarke 6470168에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke 6470168 17 페이지. Abrasive cut-off saw
페이지 인쇄
f. Keep cutting tools sharp and clean. Properly maintained cutting tools
with sharp cutting edges are less likely to bind and are easier to control.
g. Use the power tool, accessories and tool bits etc. in accordance with
these instructions, taking into account the working conditions and the
work to be performed. Use of the power tool for operations different
from those intended could result in a hazardous situation.
5) SERVICING
a. Have your power tool serviced by a qualified repair person using only
identical replacement parts. This will ensure that the safety of the power
tool is maintained.
ADDITIONAL WARNINGS FOR CUT-OFF SAWS
1. IMPORTANT: You should not operate this machine unless you are thoroughly
familiar with metal cutting saws. If there is any doubt whatsoever, you
should consult a qualified person.
2. Ensure the cutting disc is securely mounted in accordance with these
instructions before connecting to a power supply.
3. DO NOT over tighten the cutting disc. This can cause stress and could lead
to the cutting disc shattering when under load.
4. Always check the cutting disc for cracks before use. Never use discs that
are chipped, cracked or otherwise defective.
5. Before switching the machine on, always ensure the work is properly
secured, always use the vice, never present a workpiece by hand.
6. Make all adjustments with the power off.
7. When starting a cut, always ease the tool into the work. A harsh or sudden
impact could shatter the abrasive disc.
8. Ensure the cutting disc reaches maximum speed before beginning a cut.
9. Never use the machine with the guards removed or not in their correct
position.
10. Ensure you use the correct type of cutting disc for the type of material
being cut. Never use a toothed saw blade in a machine designed to use a
cutting disc. Metal cutting & masonry cutting discs are available from your
Clarke dealer. NEVER cut magnesium, wood, or non-ferrous metals.
11. Do not perform cutting in explosive atmospheres and environments where
sparks could cause fire or explosion.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
5