Clarke CCO14 운영 및 유지보수 매뉴얼 - 페이지 9

{카테고리_이름} Clarke CCO14에 대한 운영 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CCO14 11 페이지. 355mm (14") abrasive cut-off saw

The Motor

Maintenance to the Motor is limited to changing the

carbon brushes.

These will naturally wear with use and require replacing.

They should be checked periodically as follows:

Unscrew and remove the plastic covers on the end

of the motor with a screwdriver

Pull out the brushes complete with springs and

retainers.

Check the brush length, if the 'wear line' cannot

be seen ('A' fig.8), the pair must be renewed.

Replace the brushes, taking care to ensure that the tabs, on the end of the

spring retainer ('B' fig.8), correctly enter the elongated chamber as you push

it in and screw on the cap.

SPECIFICATIONS

Motor Voltage ..................................................... 230V 50Hz 1Phase

Current Rating ..................................................... 10Amps

Power Rating ........................................................ 2,200Watts

Speed ................................................................... 3,750RPM

Disk Diameter .................................................... 14" (355mm)

Thickness ..................................................... 0.125"

Bore ............................................................. 1"

Weight ........................................................ 18kg

Dimensions (overall) ............................................ 535x310x440mm

Please note that the details and specifications contained herein, are correct at the time of going to

print. However, CLARKE International reserve the right to change specifications at any time without

PARTS & SERVICE CONTACTS

For Spare Parts and Service, please contact your nearest dealer,

or CLARKE International, on one of the following numbers.

prior notice. Always consult the machine's data plate

PARTS & SERVICE TEL: 020 8988 7400

PARTS & SERVICE FAX: 020 8558 3622

e-mail as follows:

Fig.8