Clarke CPS85 운영 및 유지보수 지침 매뉴얼 - 페이지 7

{카테고리_이름} Clarke CPS85에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CPS85 17 페이지. 85 mm plunge saw

comes to a complete stop. Never attempt to remove the saw from the work

or pull the saw backward while the blade is in motion or kickback may

occur. Investigate and take corrective actions to eliminate the cause of the

blade binding.

c. When restarting a saw in the workpiece, centre the saw blade in the kerf so

that the saw teeth are not engaged into the material. If a saw blade binds, it

may walk up, or kickback from the workpiece as the saw is restarted.

d. Support large panels to minimise the risk of blade pinching and kickback.

Large panels tend to sag under their own weight. Supports must be placed

under the panel on both sides near the line of cut and near the edge of the

panel.

e. Do not use dull or damaged blades. Un-sharpened or improperly set blades

produce a narrow kerf causing excessive friction, blade binding and

kickback.

Blade depth and bevel adjusting locking levers must be tight and secure

before making the cut. If the blade adjustment shifts while cutting, it may

cause binding and kickback.

g. Use extra caution when sawing into existing walls or other blind areas. The

protruding blade may cut hidden objects that can cause kickback.

BLADE SAFETY WARNINGS

a. The maximum speed marked on the tool shall not exceed the maximum

speed marked on the blade.

Cracked saw blades must be scrapped (repairing is not permitted).

Composite (tipped) saw blades, where the tip dimension is reduced to less

than 1 mm, shall be taken out of service

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]