Clarke CRS20Li 운영 및 유지보수 지침 매뉴얼 - 페이지 7

{카테고리_이름} Clarke CRS20Li에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CRS20Li 13 페이지. 20v cordless reciprocating saw

FITTING THE BATTERY PACK (NOT SUPPLIED)

This reciprocating saw requires a 20V battery pack (6487040) and 1 Hour

Charger (6487050) to operate. Both are available separately from your local

Clarke dealer.

TO FIT THE BATTERY

1. Slide the battery pack onto the

base of the lamp.

TO REMOVE THE BATTERY

1. Press and hold the release buttons

on the side of the battery pack.

2. Slide the battery pack away from

the base of the handle.

WARNING: BEFORE REMOVING, OR INSTALLING A BLADE, MAKE SURE

THAT THE BATTERY IS REMOVED FROM THE RECIPROCATING SAW .

1. Twist the chuck counterclockwise

and hold in position.

2. Insert the saw blade as far as

possible with the teeth pointing

downward.

3. Release the chuck to close it.

• Check that the saw blade is

firmly locked in place

CAUTION: THE RETRACTED BLADE LENGTH SHOULD BE LONGER THAN THE

WIDTH OF THE WORKPIECE. IF THE BLADE IS SHORTER, THE TIP WILL JAM IN

THE WORKPIECE DURING CUTTING, POSSIBLY CAUSING INJURY AND

DAMAGING THE BLADE OR WORKPIECE.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]