Clarke CRS710V 운영 및 유지보수 지침 매뉴얼 - 페이지 10

{카테고리_이름} Clarke CRS710V에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CRS710V 17 페이지.

CUTTING TIPS

WARNING: IF THE CUTTING OPERATION IS DUSTY, WE RECOMMEND THAT

YOU WEAR A DUST

• Allow the tool to reach full speed before touching the work material.

• Guide the saw blade into the workpiece keeping the shoe pressed

firmly against the workpiece while cutting to prevent tool kickback.

• Do not press too hard, if the saw slows down as it is cutting, apply less

pressure.

• Allow the saw to come to a complete stop before setting it down.

• To prevent accidents, turn off the saw and disconnect its power

supply after use. Clean, then store the saw indoors out of the reach

of children.

Plunge cut into plywood and thin board panels. Do not attempt to plunge cut

into thick, hard wood or metal panels.

1. Clearly mark the line of cut.

2. From a convenient starting point within the cutting area, place the tip of

the blade over that point with the saw parallel to the line of cut.

3. Place the edge of the pivot shoe

on the work piece with the blade

NOT touching the work material.

• Never start a plunge cut with

the blade tip touching the work

piece. this will cause an

immediate kick back that can

damage the work piece, the

blade or cause injury.

4. Squeeze the trigger. When the

saw reaches full speed, slowly rotate the tool on the pivot shoe until the

blade has penetrated through the work material.

• Hold the tool firmly.

5. Press the pivot shoe firmly against the work material and continue to make

the cut.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]

MASK.