Clarke WOODWORKER CTS800B 운영 및 유지 관리 지침 - 페이지 7
{카테고리_이름} Clarke WOODWORKER CTS800B에 대한 운영 및 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke WOODWORKER CTS800B 15 페이지. 8” 200mm table saw
페이지 인쇄
PRE-ASSEMBLY CHECK
Unpack your Table Saw and lay out the various components, checking to ensure
that all parts detailed below have been supplied. Should any of the components
be missing or damaged then please contact your dealer immediately.
A
B
C
D
E
F
A
E
Some minor assembly work is required, as follows:
1.
Attach the handle, arrowed in the illustration above, using the screw to secure.
2.
The Rip Fence. Simply insert the knob headed screws through the holes in the
end of the fence and screw on the clamp plates.
BEFORE USE, the Table Saw MUST be bolted firmly to either a workbench or a piece
of sturdy plywood, and this must then be firmly clamped to a workbench before
use. See Mounting the Saw.
Table Saw with fitted plug
Rip Fence assembly
Push Stick
O
45
Cross Cut Guide
Crank Handle C/w Screw
Knob Headed Screws with clamp
(For use with Ripfence)
Fig.1
B
7
1
1
1
1
1
2
C
D
F