Clarke 6926011 운영 및 유지 관리 지침 - 페이지 7

{카테고리_이름} Clarke 6926011에 대한 운영 및 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke 6926011 13 페이지. Halogen heaters

OPERATION

1. Place the heater where needed and lock the braked caster(s) to prevent it

from moving. When moving the heater use the handles.

2. Slacken the locking knobs and rotate the heater body to the required

angle. Tighten the knobs on each side to lock into place (SP models only).

3. Connect the mains cable to a suitable power supply.

4. Use the on/off switches to turn on either one, or both halogen tubes.

IMPORTANT: When using the SP model heaters, avoid tilting the heater

downwards even though the tilt safety switch may cut in to prevent

overheating of both the heater and the floor.

CLEANING & MAINTENANCE

If the heater has been in use always disconnect it from the power supply and

let it cool down for at least 15 minutes before performing any cleaning or

maintenance tasks.

PERIODICALLY

• If there is a build up of dirt, wipe thoroughly with a damp cloth. Take

care that no moisture enters the heater. Take care NOT to touch the

halogen tubes with your fingers.

• Check the mains cable for damage. Heat will cause the cable to

stiffen and crack. If this is found, have the cable replaced. Check

cable routing and ensure it is well away from the heat source.

• Ensure halogen tubes are free of dust (use compressed air to clean if

possible. (ALWAYS wear a dust mask if performing this operation)

• Refer to your Clarke dealer if internal maintenance is required.

• When storing the heater, let it cool down, then keep it in a dry,

ventilated place.

FITTING/ REPLACING QUARTZ HALOGEN TUBES

Before attempting to fit/replace halogen tubes, ensure the heater is switched

off and isolated from the electrical supply.

Never hold the halogen tubes with bare hands. Always handle using either a

soft clean glove or a piece of soft clean cloth wrapped around the tube.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]