Clarke DEVIL 350 230V 운영 및 유지 관리 지침 - 페이지 6

{카테고리_이름} Clarke DEVIL 350 230V에 대한 운영 및 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke DEVIL 350 230V 13 페이지.

DEVIL 350 (110V) UNITS

The 110V model is fitted with a 32 amp, three pin industrial plug to EN 60309

and MUST be connected to a 110-130 volt, 1 phase 50Hz supply through a

suitably fused isolator switch. On no account must a 230V, 13amp (BS1363)

plug be used.

NOTE: If a portable 110V transformer is used, make sure it has a rated

capacity sufficient to take the load of the heater.

In the event that the heater is hard wired into the electrical system, it must be

carried out in accordance with IEE regulations.

If in any doubt, consult a qualified electrician. DO NOT attempt any electrical

repairs yourself.

UNPACKING AND ASSEMBLY

Before assembling, please check

contents against the following list and

advise your dealer immediately if any

parts are missing.

• 1 x Heater

• 2 x Legs

• 1 x handle

1. Remove the screws from their

locations in the heater and use

them to attach the legs.

2. Repeat with the two remaining screws to fit the handle as shown.

3. DO NOT use the heater without fitting the legs.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]