Clarke DEVIL 350B 110V 운영 및 유지 관리 지침 - 페이지 6

{카테고리_이름} Clarke DEVIL 350B 110V에 대한 운영 및 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke DEVIL 350B 110V 17 페이지.

fused isolator switch. On no account must a 230V, 13 amp (BS1363) plug be

used.

NOTE: If a portable 110V transformer is used, make sure it has a rated

capacity sufficient to take the load of the heater.

If the heater is hard wired into the electrical system, all work must be carried

out in accordance with IEE regulations.

If in any doubt, consult a qualified electrician. DO NOT attempt any electrical

repairs yourself.

UNPACKING AND ASSEMBLY

Before assembling, please check contents against the following list and advise

your dealer immediately if any parts are missing.

• 1 x Heater

• 2 x Legs

• 1 x Handle

• 1 x Remote Controller (batteries not included)

• 1 x Set fixings (screwed into back of the heater)

CAUTION: TAKE CARE TO REMOVE ALL PACKAGING MATERIALS FROM

WITHIN THE FRONT OF THE HEATER. YOU WILL NEED TO RELEASE THE

SCREWS SECURING THE FRONT GRILLE IN ORDER TO DO THIS.

1. Remove the 4 lower screws from

the heater and use them to attach

the legs as shown.

2. Repeat with the two remaining

screws to fit the handle as shown.

3. DO NOT use the heater without

fitting the legs.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]