Clarke Devil 6002 운영 및 유지보수 지침 매뉴얼 - 페이지 9

{카테고리_이름} Clarke Devil 6002에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke Devil 6002 20 페이지. Electric fan heaters

3-position fan speed control

thermostatic

temperature control

The thermostat will then switch the heater on and off automatically to control

the room temperature according to the pre-set value, maintaining a

constant room temperature.

When using the heater to warm a cold room, first turn the thermostat to MAX

and run the heater on full power until the room temperature reaches the

required value, then turn the thermostat anti-clockwise until it switches off.

When using the heater for the first time a slight emission of smoke may be

noticed. This is quite normal and soon stops. It is caused by residual traces of

oil remaining on the element from production.

After use, turn the thermostat to the OFF position and turn the selector switch

to the Fan Only position, and leave the unit to cool down for a couple of

minutes.

5KW, 9KW &15KW HEATERS

The 5 & 9kw units have a three-position twist control for FAN only, and FAN

plus either half or full heat output. The 15kw unit has a four position control;-

FAN only, FAN + 1/3, FAN + 2/3 & FAN + full heat output. A thermostatic

temperature control is also provided for fine control of heat output at a

constant pre-set temperature.

Should the heater overheat, a thermal cutout will operate, shutting down the

unit. If this happens, allow time for the unit to cool (approx. 10 minutes) before

pressing the RESET using a suitable tool, and restarting the heater.

When switching the unit OFF, it is strongly recommended that the unit is run in

the FAN ONLY mode for approx. 10 minutes, in order to cool the heating

elements, before switching OFF completely and finally disconnecting from

the mains supply.