Clarke DEVIL 7005 운영 및 유지보수 지침 매뉴얼 - 페이지 7
{카테고리_이름} Clarke DEVIL 7005에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke DEVIL 7005 17 페이지. 5kw electric fan heater
Clarke DEVIL 7005에 대해서도 마찬가지입니다: 운영 및 유지보수 지침 매뉴얼 (17 페이지)
페이지 인쇄
SAFETY SYSTEMS
THERMOSTATIC PROTECTION
The Devil 7005 has a thermal cut out to prevent the unit from overheating.
The thermal cutout may also operate
if the heater is shut down without
allowing to cool sufficiently. If
subsequently, the heater fails to start,
press the RESET button and try again.
ELECTRICAL CONNECTIONS
WARNING: THE INSTALLATION OF THIS APPLIANCE SHOULD BE CARRIED
OUT BY A COMPETENT ELECTRICIAN AND BE IN ACCORDANCE WITH THE
CURRENT IEE WIRING REGULATIONS (BS7671-2:2008).
The supply cable required is fitted with a red 5 pin 16 amp industrial plug to EN
60309.
This heater MUST be connected to a 400 Volt, 3 phase 50Hz supply through a
suitably rated isolator switch. It cannot be operated from a single phase
supply.
If in any doubt, consult a qualified electrician. DO NOT attempt any electrical
repairs yourself.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
7