Clarke Devil IRD20B 운영 및 유지보수 지침 매뉴얼 - 페이지 12

{카테고리_이름} Clarke Devil IRD20B에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke Devil IRD20B 17 페이지. Infrared diesel heater

페이지 인쇄

FAULT CODE DISPLAY

The digital display can show the following fault codes.

FAULT CODE

FO:- Operation error

F1:- Photocell error

F2:- Temperature

control sensor error

F3:-Thermostat error

HEATER SHUT DOWN & RE-STARTING

1. Set the power switch to the OFF position but do not unplug from the mains.

NOTE: When the heater is shut down, the fan will continue running for 5

minutes to expel hot air and cool the casing. For this reason the

heater should not be unplugged.

2. Only for extended shutdown should the heater be unplugged from the

mains supply.

3. If re-starting, wait 10 seconds after shutting off the heater before re-starting.

4. Set the power switch to the ON position and follow the startup procedure

above.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]

CAUSE

1. Heater is switched on

before being plugged

in.

1. No fuel

2. Fuel is contaminated

3. Photocell is dirty or

damaged.

4. Fuel Filter is dirty.

5. Ignition error

1. Damaged cable

2. Sensor is damaged.

1. Internal parts over

heating.

2. Anti-tilting sensor

activated.

1. External temperature

below -9

1. Air temperature over

SOLUTION

1. Disconnect from power

supply, switch off and

then plug in again

before switching on.

1. Switch off and refill the

tank.

2. Switch off, empty and

refill the fuel tank. Clean

the filter with clean fuel.

3.Contact your dealer.

4. Clean filter.

5. Contact your dealer.

1. Contact your dealer.

2. Contact your dealer.

1. Turn the heater off and

wait until it has cooled

down.

2. Reposition heater on a

level surface.

1. Wait for normal

temperature conditions

1. Wait for normal

temperature conditions