Clarke XR 155 운영 및 유지 관리 지침 - 페이지 17

{카테고리_이름} Clarke XR 155에 대한 운영 및 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke XR 155 20 페이지. Paraffin/diesel heaters
Clarke XR 155에 대해서도 마찬가지입니다: 운영 및 유지보수 매뉴얼 (8 페이지)

페이지 인쇄

TROUBLE-SHOOTING

FAULT

Motor does not start

Motor runs, but the

heater does not ignite.

Flames emitted from

Air Outlet

Heater starts normally, 1. Dirty photocell

but flame-out control

system shuts off the

CAUSE

1. No power

2. Faulty Motor/Capacitor

3. Lock out of appliance

due to overheating.

4. Internal Fuse Blown

1. Empty fuel tank, dirty or

wrong fuel.

2. Fuel filter clogged

3. Air leaks in fuel line

4. Burner nozzle Clogged

5. Oil viscosity increased due 5. Mix with 10-20% paraffin.

to low temperature.

1. Insufficient air flow into

combustion chamber.

2. Pump pressure too high.

2. Faulty photocell

3. Defective connection

between photocell and

flame-out control

4. Faulty flame-out control

REMEDY

1. Check power supply, power

cable and fuse, and replace

if necessary. Check External

Thermostat if fitted.

2. Check and if necessary,

replace

3. Detect cause of overheating.

Check air inlet and outlet.

Wait for 5 minutes, and

restart. If condition persists

contact your Clarke dealer

4. Check an replace fuse

1. Drain dirty or wrong fuel,

clean filter and fill with clean

paraffin or equivalent.

2. Clean or replace fuel filter

3. Check pipes, tighten

connections, if necessary

replace pipe.

4. Clean nozzle with compressed

air. Replace if necessary

1. Check air inlet is not blocked.

Check fan is not damaged

and is operating correctly.

2. Check air pump pressure,

and reduce to nominal value.

1. Check photocell and ensure

it acknowledges the flame.

(Contact your Clarke dealer)

2. Replace photocell.

3. Check, and connect

properly.

4. Check and replace if

necessary