Clarke CAT218 운영 및 유지 관리 지침 - 페이지 11

{카테고리_이름} Clarke CAT218에 대한 운영 및 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CAT218 17 페이지. 6pc air scraper tool set

SERVICE AND REPAIR

If the tool runs erratically or becomes inefficient although the air supply is in

good order, it may be necessary to dismantle the air motor and replace any

worn or damaged parts. Such servicing and repair work should be carried out

by a qualified service technician.

PERFORMANCE

Please note that factors other than the tool may effect its operation and

efficiency such as reduced compressor output, excessive drain on the airline

moisture or restrictions in the air-line, or the use of connectors of improper size

or poor condition which will reduce air supply.

**CLARKE Air Line Oil (part no. 3050825) is available from your CLARKE dealer.

STORAGE

If the tool is to be stored, or is idle for longer than 24 hours, run a few drops of

Clarke air line oil into the air inlet and run the tool for 5 seconds in order to

lubricate the internal parts.

When not in use, disconnect from the air supply, clean the tools and when

storing, replace the blanking plug once the airline is disconnected.

ACCESSORIES

A wide range of accessories is available including filter/regulators, lubricators,

high-pressure hoses (5 to 50 metres) etc. Contact your CLARKE dealer for

further information or CLARKE International Service Department.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]