Clarke CDTJ24 운영 및 유지보수 지침 매뉴얼 - 페이지 8
{카테고리_이름} Clarke CDTJ24에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CDTJ24 12 페이지. Dovetail jig
페이지 인쇄
SETTING THE BACKSTOP POSITION
The distance the backstop needs to be positioned from the front of the
template fingers depends on the size of router base fitted to your router,
The formula to calculate this is:-
router base diameter
(
2
EXAMPLE
Using a router which has a base diameter of 160 mm, making a drawer that
has sides 18 mm thick and using the standard cutter supplied with a tip
diameter of 14.8 mm.
router base diameter
(
2
160 mm
(
2
(
80 mm
The distance from the tips of the template fingers to the vertical face of the
backstop should be set at 108.6 mm.
1. Set a micrometer or vernier
caliper to the calculated depth
and adjust the backstop as
shown.
2. Lock into place using the
backstop locking screws.
• It is not essential that this setting
is exact at this stage as final
adjustments can be made later
on.
• Ensure that the template and back stop stay parallel with the front
edge of the jig during this setting procedure.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
)+(
2 x width of the drawer sides
)+(
2 x width of the drawer sides
)+(
2 x 18 mm
)+(
36 mm
Distance = 108.6 mm
)-(
)-(
)-(
)-(
8
cutter tip diameter
2
cutter tip diameter
2
)
14.8 mm
2
)
7.4 mm
)
)