Clarke CHT637 운영 및 유지 관리 지침 - 페이지 7

{카테고리_이름} Clarke CHT637에 대한 운영 및 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CHT637 16 페이지. Air operated clutch & brake bleeding kit

PRINCIPAL OF OPERATION

The Clarke clutch & brake bleeding kit is designed for one-man operation. It is

used to drain brake fluid from a hydraulic system such as the clutch or brake

systems on an vehicle. It can also be used to extract a variety of fluids from

reservoirs including the master cylinders or those for power steering fluid.

It uses a normal workshop compressed air supply between 70 to 170 psi (4.8-

11.6 bar), to create a vacuum in the tank. The vacuum can be connected

by attaching the adapter to the fluid inlet plug located on the top of the unit.

The automatic refill bottle is designed for use with a standard bottle of brake

fluid, to maintain an adequate fluid level in the master cylinder while the

hydraulic system is bled. The bleeder air inlet will shut off automatically when

the hydraulic fluid reaches the maximum level.

OPERATING INSTRUCTIONS

IMPORTANT:

In addition to this manual, always follow the manufacturers recommended

procedures when servicing each vehicle.

REMOVING OLD HYDRAULIC FLUID FROM THE MASTER CYLINDER

1. Park the vehicle securely on level

ground with the engine off.

2. Clean the outside of the master

cylinder and master cylinder cap

to prevent dirt entering the

master cylinder when the cap is

removed.

3. Remove the cap from the master

cylinder reservoir.

4. Connect compressed air supply

to the Air Inlet Valve (I).

Parts & Service: 020 8988 7400/E-mail:[email protected] or [email protected]