Clarke CMFT250 운영 및 유지 관리 지침 - 페이지 6

{카테고리_이름} Clarke CMFT250에 대한 운영 및 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CMFT250 20 페이지. Multi function tool kit

2. Use a metal detector to determine if there are gas or water pipes hidden

in the work area or call the local utility company for assistance before

beginning the operation. Striking or cutting into a gas line will result in

explosion. Water entering an electrical device may cause electrocution.

3. Keep hands away from cutting area. Do not reach under the material

being cut. The proximity of the blade to your hand is hidden from your

sight.

4. Do not use dull or damaged blades. Bent blades can break easily or

cause kickback.

5. Exercise caution when handling the accessories. The accessories are very

sharp.

6. Wear protective gloves when changing cutting accessories. Accessories

become hot after prolonged usage.

7. Limit the exposure time to vibration by taking frequent rest periods.

Vibration caused by the tool may be harmful to the hands and arms.

8. Before scraping, check the workpiece for nails. If found, either remove

them or set them well below intended finished surface. Striking a nail with

accessory edge could cause the tool to jump.

9. Do not wet sand with this tool. Water entering the motor housing is an

electrical shock hazard.

10. Never work in area which is wet or damp such as newly applied

wallpaper. There is an electrical shock hazard when working in such

conditions with a power tool and heating of the water caused by

scraping action may cause harmful vapours to be emitted from

workpiece.

11. Always wear eye protection and a dust mask for dusty applications and

when sanding overhead. Sanding particles can be absorbed by your eyes

and inhaled easily and may cause health complications.

12. Use special precautions when sanding chemically pressure treated

lumber, lead-based paint, or any other material that may contain

carcinogens. A suitable breathing respirator and protective clothing must

be worn by persons entering the work area. The work area should be

sealed by plastic sheeting and persons not protected should be kept out

until work area is thoroughly cleaned.

13. Do not use sandpaper intended for larger sanding pads. Larger

sandpaper will extend beyond the sanding pad causing snagging, tearing

of the paper or kick-back. Extra paper extending beyond the sanding pad

can also cause cuts.

Please keep these instructions in a safe place for future reference.

Parts & Service: 020 8988 7400/E-mail:[email protected] or [email protected]