Clarke CONTRACTOR CWJ700 운영 및 유지보수 지침 매뉴얼 - 페이지 5

{카테고리_이름} Clarke CONTRACTOR CWJ700에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CONTRACTOR CWJ700 20 페이지. Worktop jig

Using The Jig

Rear View

Before Starting:

ensure the worktop is firmly supported on trestles or similar.

ensure the jig is firmly secured to the worktop using no less than 2 quick

woodworking clamps or similar.

ensure there are no obstructions in the path of the router, also the router cutter

beneath the worktop, i.e. the cutter doesn't cut into the bench/trestle when cutting

through the worktop.

use only good quality sharp tungsten router bits.

cut into the post form edge (curved edge) of the worktop to avoid break out or

chipping of the laminate.

keep the router vertical to the jig and laminate.

keep the jig surface clean.

exceed 10mm depth of cut in one pass.

remove or position the router whilst the cutter is still rotating.

PLEASE NOTE: for illustrative purposes only, all diagrams and instructions in this manual

make reference to 700mm worktops, but apply equally to all sizes of worktop ranging

from 400mm to 900mm

Fig. 2

ALWAYS

NEVER

Front View

Fig. 1

-4-