Clarke METALWORKER CTR1 운영 및 유지보수 지침 매뉴얼 - 페이지 6

{카테고리_이름} Clarke METALWORKER CTR1에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke METALWORKER CTR1 8 페이지. Tube roller

OPERATION

1. Turn the Rotary Handle on top

counter-clockwise, which will raise

the Upper Roller.

2. After raising the bottom edge of the

Upper Roller above the top edges of

the Bottom Rollers, place the work

piece into the tools cutouts of the

rollers until it is contacting all three

rollers, then using the Rotary Handle

to tighten the Travelling Bolt down by

a 1/4 of a turn to put light pressure on

the tubing.

3. Facing the Driving Handle, begin

forming by feeding your tubing into

the left hand side of the tool while

turning the Driving Handle clockwise

and tightening down gently with the

Rotary Handle.

4. When creating tighter radii, you may need to spiral your work piece slightly

to clear the body of the tool. This can easily be flattened out after

completion.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]