Clarke X-pro CAT164 운영 및 유지 관리 지침 - 페이지 7

{카테고리_이름} Clarke X-pro CAT164에 대한 운영 및 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke X-pro CAT164 17 페이지. Needle scaler/chisel kit

BEFORE USE

FITTING THE NEEDLE HOLDER

The Needle Scaler is packed in two

halves:

• The main body/drive assembly

• The needle holder with needles

1. Screw the needle holder with

needles, firmly onto the nose of the

tool.

• Tighten the three grub screws

shown with a hex key to secure

the needle tube in place.

FITTING THE CHISELS

1. Insert the chisel into the air

hammer as shown.

2. Screw the retaining spring fully

onto the main body.

• Use the lugs to gain purchase

and tighten.

WARNING: COMPRESSED AIR CAN BE DANGEROUS. ENSURE THAT YOU

ARE FAMILIAR WITH ALL PRECAUTIONS RELATING TO THE USE OF AIR

COMPRESSORS AND A COMPRESSED AIR SUPPLY.

1. Remove the protective plug from the air inlet port and connect a suitable

hose.

2. A gauze filter is fitted within the air inlet adapter. Ensure this filter is always in

place and clean. The airline is connected to the adapter, preferably via a

quick release coupling (not supplied).

3. Connect the other end of the hose to the compressor.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]