3Com 3CRWX5850GS - AirProtect Sentry 5850 Wireless Intrusion Prevention Sys 빠른 시작 매뉴얼 - 페이지 6
{카테고리_이름} 3Com 3CRWX5850GS - AirProtect Sentry 5850 Wireless Intrusion Prevention Sys에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3Com 3CRWX5850GS - AirProtect Sentry 5850 Wireless Intrusion Prevention Sys 15 페이지. Wireless intrusion prevention system
3Com 3CRWX5850GS - AirProtect Sentry 5850 Wireless Intrusion Prevention Sys에 대해서도 마찬가지입니다: 데이터시트 (4 페이지)
페이지 인쇄The figures below show a cable being routed through the large opening in the cradle and
then the cradle being mounted to a wall.
3
Connect the Ethernet cable (for power and network connection) to the port on the rear of
the Sentry.
4
Twist the Sentry onto the mounting bracket.
Tabletop Mounting
To install the Sentry on a flat surface such as a table or desktop:
1
Remove the backing from the four rubber feet and attach them on the bottom of the Sentry.
2
Place the Sentry on the table.
3
Connect the Ethernet cable (for power and network) to the port on the rear of the Sentry.
5. Connecting Power
The Sentry can be powered by the following methods:
•
By Power Over Ethernet (PoE) supplied over the LAN by a 802.3af PoE compliant device such
as a switch or hub.
•
By PoE supplied by a PoE injector (not included).
Power Over Ethernet (PoE) from the LAN
To power the Sentry using PoE provided by a switch or other 802.3af compliant device, simply
plug the network cable from the device into the Sentry's Ethernet port.
Sentry
Routing a cable
Wall-mounting the cradle
PoE Switch/Hub
6