CTM LYNG Microsafe mKomfy Hybrid R-T 설치 지침 매뉴얼 - 페이지 6
{카테고리_이름} CTM LYNG Microsafe mKomfy Hybrid R-T에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CTM LYNG Microsafe mKomfy Hybrid R-T 16 페이지. Cooker guard
CTM LYNG Microsafe mKomfy Hybrid R-T에 대해서도 마찬가지입니다: 사용자 지침 (2 페이지)
페이지 인쇄Installation – Sensor
NB: The sensor and relay are factory-paired and ready to install
Fitting the sensor
•
The sensor must be fitted at least 70 cm above the hob, either in the
hood or on the ceiling.
•
Take note of the coverage (page 7) when fitting the sensor at different
heights.
•
The mounting hole is suitable for mounting on a standard wall box.
1.
Find a suitable location, see drawings on page 8-10.
2.
Mount the bracket.
3.
Set the DIP switches to the chosen height and angle (page 12).
4. Insert the batteries (2 beeps = OK), or connect an external
power supply.
5.
Put the sensor in the bracket and press the control button on
the sensor once. A short beep confirms that the sensor is in
communication with the socket and working.
6. Make sure that only the green LED on the relay lights up when the
cooker is connected and turned off. If the yellow LED lights up, the
cooker's standby electricity consumption is higher than the default
setting. In this case the level in the mKomfy can be calibrated to the
cooker's actual electricity consumption, see page 12.
Power supply
The sensor can be used with batteries (3 x AA, supplied) or an external
power supply.
NB: It is not possible to use batteries and a power supply at the same time.
The batteries must be removed if an external power supply is used.
Skins for the front panel
On our website, you can find dimensioned sketches for making
your own skins, which you can cut to size and position under
the sensor's front panel.
See www.ctmlyng.no/hybrid
6
See page 15 if re-pairing is necessary