CLAS OC 0802 매뉴얼 - 페이지 9

{카테고리_이름} CLAS OC 0802에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CLAS OC 0802 16 페이지. 10t collision repair set

OC 0802

10T COLLISION REPAIR SET

SECURITY

Hose

Before operating the pump, tighten all hose connections using the correct tools. Do not overtighten; connections

need only be secure and leak-free. Overtightening can cause premature thread failure or high pressure fittings to

split at presssures lower their rated capacities.

Should a hydraulic hose ever rupture, burst, or need to be disconnected, immediatly shut the pump OFF, and

open the control valve to release all presure. NEVER grasp a leaking, pressurized hose with your hands; the

force of escaping hydraulic fluid could cause serious injury.

Do not subject the hose to any potential hazard such as fire, extreme cold or heat, sharp surfaces, or heavy

impact. Do not allow the hose to move attached equipement. Periodically inspect the hose for wear, because

any of these conditions can damage the hose and result in personal injury.

Hose material and coupler seals must be compatible with the hydraulic fluid used. Hoses also must not come

in contact with corrisive materials such as creosote-impregnated objects and some paints. Never paint couplers

and/or hoses. Hose deterioration due to corrsive material can result in personal injury.

Pump

Do not exceed the maximum capacity of the pump or tamper with the internal high pressure relief valve. Creating

pressure beyond the rated capacity can result in personal injury.

Completly retract the ram before opening the filler screw on the pump to add hydraulic fluid.

An overfill can cause personal injury due to excess reservoir pressure created when rams are retracted.

Ram

Do not exceed the maximum capacity of the ram. Creating pressure beyond the rated capacity can result in

personal injury.

Do not set poorly-balanced or off-center loads on a ram. The load may tip and cause personal injury.

The use of extension tubes or off-center attachments greatly reduces the capacity of the hydraulic system. When

using extension tubes, put the shortest tubes on the ends of the setup; never put the shortest tubes in the middle of

the setup.

Some components in this set do not match the maximum pressure rating of the pump and ram. Use a pressure

gauge in the system to monitor hydraulic pressure.