CLAS OM 8036 빠른 시작 매뉴얼 - 페이지 15
{카테고리_이름} CLAS OM 8036에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CLAS OM 8036 16 페이지. 2nd generation tool bearing removal 62-85mm
페이지 인쇄OM 8036
2nd GENERATION TOOL BEARING REMOVAL Ø62-85mm
INSERTION
During insertion, the thrust force is exerted in the groove at the bottom of the bearing's outer cage (see fig. 1),
through the insertion semirings
Carry out the insertion by assembling the following tool set components as shown in fig. 9:
• 2 insertion semirings
• Insertion ring
, appropriately sized to the diameter of the bearing seat;
I
• Thrust bell
D
;
• Screw M20x1.5
;
E
• Nut + bearing
F
;
• Counter-nut
.
G
8
Manual operation
- Manually tighten only the nut + bearing
insertion semirings
H
has been fully inserted into its seat (fig. 9).
Operation with 17-ton hydraulic cylinder (UPGRADE OPTION) OM 8037
- The hydraulic cylinder is placed between the bell
that, by axially translating the screw, allows you to insert the integrated HBU bearing into its seat. As when the
bearing had been removed, repeat the operation until it is completely inserted.
We recommend the use of the cylinder combined with the 700-bar manual hydraulic pump.
10
H
that are held together by means of the bell
H
, of suitable diameter (see fig. 1 and 8, for correct positioning);
on the screw M20x1.5
F
and the integrated HBU bearing, against the insertion ring (I), until the integrated HBU bearing
9
E
G
, so as to push the bell
E
D
and a second counter-nut
11
G
D
.
H
D
I
F
, jointly with the 2
D
G
(fig. 11). Now actuate the cylinder
G