CLAS OP 1418 매뉴얼 - 페이지 7

{카테고리_이름} CLAS OP 1418에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CLAS OP 1418 8 페이지. 3/8" d. butterfly impact wrench kit

OP 1418

3/8" D. BUTTERFLY IMPACT WRENCH KIT

OPERATING INSTRUCTIONS

Use accessories recommended by Sunmatch.

Check the position of the reversing mechanism before operating the tool so as to be aware of the direction of

rotation when operating. Use only impact sockets and accessories.

Do not use the hand sockets or accessories.

Check the drive end of the tool to make sure that the socket retainer functions correctly and that sockets and drive

ends are not excessively worn which may allow the socket to come off when rotating.

Connections requiring speci c torque must be checked with a torque meter after tting with an impact wrench.

Loosening

Attach the correct size socket to the anvil. Set the compressor's pressure regulator to 90PSI. Connect the tool to

the air compressor's hose. If leakage is detected, disconnect the air hose and x it correct before use. Place the

socket over the nut to loosen. Grip the tool rmly.

Tightening

Make sure that the nut or bolt you are using the tool to tighten can withstand the rated torque. Tighten the nut as

far as you can by hand. Place the socket on the nut. Press the Reverse valve forward so it protrudes out the front

of the housing. Please the trigger to start the tool.