Lenovo ThinkStation D20 배포 매뉴얼 - 페이지 17

{카테고리_이름} Lenovo ThinkStation D20에 대한 배포 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Lenovo ThinkStation D20 28 페이지. Windows xp professional x64 edition recovery and conversion kit - japan
Lenovo ThinkStation D20에 대해서도 마찬가지입니다: 브로셔 (36 페이지), 사양 (4 페이지), 브로셔 및 사양 (4 페이지), 매뉴얼 (8 페이지), 기능 설명서 (1 페이지), (일본어) 소프트웨어 설명서 (8 페이지)

페이지 인쇄

1. Configuring Bios Settings

Chapter 3. Typical Usage

Listing current BIOS settings

Changing BIOS settings

Changing the Startup Sequence

@Copyright Lenovo 2010

Through WMI, you can configure BIOS settings in the

following ways:

·List BIOS settings

·Change BIOS settings

· Change the boot order (sometimes referred to as the startup

sequence)

·Load default BIOS settings

For a list of all available BIOS settings that can be changed

through WMI on a specific computer, use the

Lenovo_BiosSetting class (see "List all BIOS settings on the

local computer" on page 12 and "List all BIOS settings on the

remote computer" on page 14 for sample scripts).

See Table 4 on page 4 for a list of available BIOS settings.

To change a BIOS setting, complete the following steps:

1. Identify the BIOS setting you want to change using the

Lenovo_BiosSetting class (see "List all BIOS settings on the local

computer" on page 12 and "List all BIOS settings on the remote

computer" on page 14 for sample scripts).

2. Identify the value to which the setting will be changed.

Note: See Table 4 on page 4 for a list of available values for a

particular setting.

3. Change the BIOS setting to the desired value using the

Lenovo_SetBiosSetting class, then use the Lenovo_SaveBiosSetting

class to save the settings (see "Set a single BIOS setting on the local

computer" on page 12 and "Set a single BIOS setting on a remote

computer" on page 14 for sample scripts).

Note: BIOS settings and values are case sensitive.

After making changes to the BIOS settings, you must reboot the

computer before the changes will take effect.

To change the startup sequqence, complete the foll\ owing steps:

Determine the current setting for "StartupSequence" by using