CLAS OE 3010 매뉴얼 - 페이지 8

{카테고리_이름} CLAS OE 3010에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CLAS OE 3010 12 페이지. Voltage detector

OE 3010

Atlernating current

Direct current

Caution, risk of danger, refer to the operating manual before use

Caution, risk of electric shock

Earth (ground) terminal

Conform to European Uniondirectives

The equipment is protected throughout by double insulation or reinforced insulation

Adhere to local and national safety codes. Use protective equipment to prevent shock and arc blast injury when

working near hazardous live conductors.

• Use caution when working with voltages above 6oV dc, 3oV ac rms or 42V ac peak. Such voltages pose a

shock hazard.

• Max voltage for use: CAT lll 69oV

• Before and after using the tester, verify its operation by measuring a known voltage.

• To avoid electric shock, do not touch any metal probe and naked conductor with hand or skin.

• Never perform continuity test on a live circuit. However, in the event of an incorrect operation, the tester provides

protection up to 6ooV.

• Do not use the tester if it operates abnormally or if it is damaged.

• Do not operate the tester in a place where ammable or explosive gas (or dust) is present.

• To avoid electric shock, do not hold the tester anywhere beyond the tactile barrier.

• Do not use the red test probe and the black test lead with other equipments.

• Remaining endangerment: When a probe or input terminal is connected to dangerous voltage, this voltage can

occur at the other probe or input terminal!

• When using the probes, keep your ngers behind the nger guards on the probes.

• Keep the tester out of reach of child and infant.

• CAT Ill - Measurement Category III is for measurements performed in the building installation. Examples are

measurements on distribution boards, circuit breakers, wiring, including cables, bus-bars, junction boxes, switches,

socket-outlets in the xed installation, and equipment for industrial use and some other equipment, for example,

stationary motors with permanent connection to the xed installation. Do not use the meter for measurements within

Measurement Categories IV.

VOLTAGE DETECTOR

SYMBOL

SAFETY