Lenovo 42U 1200 mm Deep Dynamic Rack 설치 매뉴얼 - 페이지 29
{카테고리_이름} Lenovo 42U 1200 mm Deep Dynamic Rack에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Lenovo 42U 1200 mm Deep Dynamic Rack 42 페이지.
페이지 인쇄
Chapter 4. Managing cables
Always read the instructions that come with your server or optional device for detailed cable-management
information. Use the following general guidelines when cabling servers or optional devices that you install
in a rack.
Statement 8:
DANGER
•
Plug power cords from devices in the rack cabinet into electrical outlets that are located
near the rack cabinet and are easily accessible.
•
Each rack cabinet might have more than one power cord. Be sure to disconnect all power
cords in the rack cabinet before servicing any device in the rack cabinet.
•
Install an emergency-power-off switch if more than one power device (power distribution
unit or uninterruptible power supply) is installed in the same rack cabinet.
•
Connect all devices installed in a rack cabinet to power devices installed in the same rack
cabinet. Do not plug a power cord from a device installed in one rack cabinet into a power
device installed in a different rack cabinet.
•
Do not run cables in front of or behind other devices that will prevent service access to those devices.
•
Do not bend fiber-optic cable beyond its specified limits.
•
Label all cables so that they are clearly distinguishable from each other.
•
When installing devices mounted on slide rails, such as servers, observe the following precautions:
-
Run the cables neatly along equipment cable-management arms and secure the cables to the
arms using provided cable straps.
-
Leave enough extra cable so that the device can fully extend without straining the cables.
-
Secure the cables so that the device can retract without pinching or cutting the cables.
•
When installing devices mounted on fixed rails, observe the following precautions:
-
Run the cables neatly along the posts or side rails in the rack out of the way of other installed
devices.
-
Secure the cables with the provided cable straps.
•
Make sure that the cables cannot be pinched or cut by the rack rear door or other devices.
•
Run internal cables that connect devices in adjoining racks through the large openings in the rear of the
rack.
•
Run external cables through the bottom of the rack or through the cable-access opening in the top of the
rack.
Cable-routing brackets
To route cables neatly in the rear of the racks, use the cable-routing brackets that come in the hardware
kit. The rack comes with eight cable-routing brackets. Use a screwdriver to install or remove a bracket on
the rack-mounting flange in the rear of the rack.
29