CTS EPS-3112 사용자 설명서 - 페이지 9

{카테고리_이름} CTS EPS-3112에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. CTS EPS-3112 19 페이지. Management layer 2 gigabit poe ethernet switch 8 poe ports 10/100/1000mbps rj-45 + 4 combo uplink ports (10/100/1000 mbps rj-45 and 100/1000mbps sfp slot)

페이지 인쇄
CTS EPS-3112 사용자 설명서
Please refer to chapter
4.
Reset Button:
Pressing reset button for 5~10 seconds then release to restart
the system.
Pressing reset button for more than 10 seconds then release to
reset the Managed Switch back to factory settings and restart
the system.
5.
Console port:
An asynchronous serial console port supporting the RS-232
electrical specification. The console port can be used to
manage the device and the interface should be configured to
115200 , N , 8 ,1
Rear Panel
The Managed Switch features one fixed AC power module and its rated input
supply voltage is from AC 100 to 240V, 50/60Hz.
The rear panel is configured as follows:
1.
AC inlet
The rated input supply voltage is from AC 100 to 240V, 50/60Hz

1.4 Cable Specifications

The following table contains various cable specifications for the Managed
Switch. Please make sure that you use the proper cable when connecting the
Managed Switch.
Cable Type
10Base-T
100Base-TX
1000Base-T
100BASE-FX
1000BASE-SX
1000BASE-LX
1000BASE-LH
1000BASE-ZX
Mini-GBIC
3.1 LED Definitions
UTP Category 3, 4, 5 (100 meters max.)
EIA/TIA- 568 150-ohm STP (100 meters max.)
UTP Cat. 5 (100 meters max.)
EIA/TIA-568 150-ohm STP (100 meters max.)
UTP Cat. 5e (100 meters max.)
UTP Cat. 5 (100 meters max.)
EIA/TIA-568B 150-ohm STP (100 meters max.)
Multi-mode fiber module(2km) / Single-mode fiber module
Multi-mode fiber module (550m)
Single-mode fiber module (10km)
Single-mode fiber module (30km/50km)
Single-mode fiber module (80km)
SFP Transceiver for 1000BASE-SX Multi-mode fiber module (550m)
SFP Transceiver for 1000BASE-LX Single-mode fiber module (10km)
SFP Transceiver for 1000BASE-LH Single-mode fiber module
9
Description