Lenovo ThinkSystem DM240N 서비스 매뉴얼 - 페이지 23

{카테고리_이름} Lenovo ThinkSystem DM240N에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Lenovo ThinkSystem DM240N 34 페이지. Hot-add a shelf, shelves, support for dg5000 and dg7000
Lenovo ThinkSystem DM240N에 대해서도 마찬가지입니다: 지침 (3 페이지), 매뉴얼 (7 페이지), 매뉴얼 (21 페이지)

페이지 인쇄

1. Chapter 1. Hot-Swapping a Drive

Chapter 6. Replacing an NSM module

You can replace an impaired NVMe shelf module (NSM) nondisruptively in an DM240N drive shelf that is

powered on, and while I/O is in progress.

Before you begin

• All other components in the system, including the other NSM module, must be functioning properly.

• You must have verified that the shelf containing the failed FRU is cabled correctly, by downloading and

running ThinkSystem Intelligent Monitoring Config Advisor. If any cabling errors are generated, follow the

corrective actions provided.

Lenovo Downloads: ThinkSystem Intelligent Monitoring Config Advisor

About this task

• Replacing the NSM module involves moving the DIMMs, fans and power supply from the impaired NSM

module to the replacement NSM module.The real-time clock (RTC) battery comes preinstalled in the

replacement NSM module.

Note: After the NSM module replacement is completed, its RTC clock is automatically synchronized by

ONTAP. RTC clock synchronization might take up to one day to initiate.

• Allow at least 70 seconds between removal and installation of the NVMe shelf module (NSM).70 seconds

is the time it takes for ONTAP to recover: clean up the data structures and the driver to register the shelf ID

correctly.

• Best practice: The best practice is to have current versions of NVMe shelf module (NSM) firmware and

drive firmware on your system before replacing FRU components.

Note: Do not revert firmware to a version that does not support your shelf and its components.

Lenovo Downloads: Disk Shelf Firmware

Lenovo Downloads: Disk Drive and Firmware

• Shelf (NSM) firmware is automatically updated (nondisruptively) on a new NSM module that has a non-

current firmware version.NSM module firmware checks occur every 10 minutes. An NSM module firmware

update can take up to 30 minutes.

• If needed, you can turn on the shelf's location (blue) LEDs to aid in physically locating the affected shelf:

storage shelf location-led modify -shelf-name shelf_name -led-status on If you do not know the shelf_

name of the affected shelf, run the storage shelf show command.

A shelf has three location LEDs: one on the operator display panel and one on each NSM module.

Location LEDs remain illuminated for 30 minutes. You can turn them off by entering the same command,

but using the off option.

• When you unpack the replacement NSM module, save all packing materials for use when you return the

failed NSM module. You return the failed part to Lenovo as described in the RMA instructions shipped

with the kit. If you need the RMA number or additional help with the replacement procedure, contact

technical support at

Lenovo Support

+800-800-80-800 (Asia/Pacific).

A video for this task is available at:

• Youtube: https://www.youtube.com/playlist?list=PLYV5R7hVcs-BhZmHgn868u8QatfgH8JW4

• Youku: https://list.youku.com/albumlist/show/id_52419127

, 888-463-8277 (North America), 00-800-44-638277 (Europe), or