Lenovo 4449HB1 사용자 설명서 - 페이지 22
{카테고리_이름} Lenovo 4449HB1에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Lenovo 4449HB1 32 페이지. Wide monitor
페이지 인쇄
Table 3-2. Troubleshooting
Problem
The power
indicator is
green, but there
is no image
One or more of
the pixels appear
discolored
•
Fuzzy lines
in text or a
blurry
image
•
Horizontal
or vertical
lines
through the
image
Manual image setup
If automatic image setup does not establish the image that you prefer, perform
manual image setup.
Note: Have your monitor powered on for about 15 minutes, until the monitor warms
up.
1.
Press
at the bottom of the monitor to open the OSD menu.
2.
Use
or
3.
Use
or
•
C C lock (pixel frequency) adjusts the number of pixels scanned by one
horizontal sweep. If the frequency is not correct, the screen shows vertical
stripes and the picture does not have the correct width.
•
P P hase adjusts the phase of the pixel clock signal. With a wrong phase
adjustment, the picture has horizontal disturbances in light picture.
4.
When the image no longer looks distorted, save the Clock and Phase adjustments.
5.
Press
Possible cause
The video signal cable
is loose or
disconnected from the
system or monitor
The monitor
brightness and
contrast are at the
lowest setting
This is a characteristic
of the LCD
technology and is not
an LCD defect
•
Image setup has
not been
optimized
•
Your system
Display
Properties setting
have not been
optimized
to select
and press
to select C C lock and P P hase adjustment.
to leave the OSD menu.
Suggested action
Be sure the video cable is
connected with the
system properly
Adjust the brightness and
contrast setting on the
OSD menu
If there are more than five
pixels missing, contact
the Support Center
Adjust the resolution
settings on your system
to match the native
resolution for this
1600x900 at 60 Hz
monitor:
Perform automatic image
setup. If automatic image
setup does not help,
perform manual image
setup
When working in the
native resolution, you
may find additional
improvements by
adjusting the Dots Per
Inch (DPI) setting on your
system
to access.
Reference
"Connecting and
turning on your
monitor" on page 1-3
"Adjusting your
monitor image" on
page 2-3
Appendix A,
"Service and
Support," on page
A-1
"Adjusting your
monitor image" on
page 2-3
"Selecting a
supported display
mode" on page 2-7
See the Advanced
section of your
system's display
properties
3-4
Chapter 3.