Lenovo 6135-AB1 사용자 설명서 - 페이지 20

{카테고리_이름} Lenovo 6135-AB1에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Lenovo 6135-AB1 29 페이지. Lenovo computer monitor - flat panel lcd computer monitor user manual

페이지 인쇄

4. When the image no longer looks distorted, save the Clock and Phase

5. Press

Manually installing the monitor driver

Below are steps for manually installing the monitor driver in Microsoft

of the Reference and Driver CD for automatic installation.

Installing the monitor driver in Windows XP

To use the Plug and Play feature in Windows XP, files should be loaded from the

Reference and Driver CD.

Note: This section must be completed before continuing with the Windows XP

automatic image setup.

10. Open the Hardware Update Wizard window by clicking on Update Driver,

11. Select Install from a list or Specific location(Advanced), and then click Next.

12. Insert the Setup CD into the CD drive, then click the Have Disk button.

13. Click OK.

14. Ensure that the CD drive letter is selected.

15. Choose L191 Monitor and click OK. The files will be copied

16. Close all open windows and remove the CD.

17. Restart the system. The system will automatically select the maximum refresh

Note: On LCD monitors, unlike CRTs, a faster refresh rate does not improve

display quality. Lenovo recommends using either 1280 x 1024 at a refresh rate of 60

Hz, or 640 x 480 at a refresh rate of 60 Hz.

Installing the monitor driver in Windows 2000

To use the Plug and Play feature in Windows 2000, files should be loaded from the

Reference and Driver CD.

3-4

Flat Panel Monitor User 's Guide

v Clock (pixel frequency) adjusts the number of pixels scanned by one

horizontal sweep. If the frequency is not correct, the screen shows vertical

stripes and the picture does not have the correct width.

v Phase adjusts the phase of the pixel clock signal. With a wrong phase

adjustment, the picture has horizontal disturbances in light picture.

adjustments.

to leave the OSD menu.

and Microsoft Windows 2000 Professional. Please see the Install Driver section

1. Turn off the computer and all attached devices.

2. Ensure that the monitor is connected correctly.

3. Turn on the monitor and then the system unit. Allow the system to boot into

Windows XP.

4. Open the Display Properties window by clicking Start →Settings →Control

Panel, and then double-clicking the Display icon.

5. Click the Settings tab.

6. Click the Advanced button.

7. Click the Monitor tab.

8. Click the Properties button.

9. Click the Drivers tab.

and then click Next.

from the CD to your hard disk drive.

rate and corresponding Color Matching Profiles.

Windows