Lenovo Yoga Slim 7i 사용자 설명서 - 페이지 23

{카테고리_이름} Lenovo Yoga Slim 7i에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Lenovo Yoga Slim 7i 34 페이지.
Lenovo Yoga Slim 7i에 대해서도 마찬가지입니다: 사용자 설명서 (46 페이지), 사용자 설명서 (34 페이지), 사용자 설명서 (36 페이지)

페이지 인쇄

Set performance mode

Your computer can work in different performance modes. The performance and power consumption of the

computer vary in different performance modes. Press Fn + Q to cycle through different performance modes.

Change settings in UEFI/BIOS setup utility

This section introduces what is UEFI/BIOS and the operations you can perform in its setup utility.

What is UEFI/BIOS setup utility

UEFI/BIOS is the first program that runs when a computer starts. UEFI/BIOS initializes hardware components

and loads the operating system and other programs. Your computer may include a setup program (setup

utility) with which you can change certain UEFI/BIOS settings.

Open the UEFI/BIOS setup utility

Step 1.

Turn on or restart the computer.

Step 2.

When the Lenovo logo appears on the screen, press F2 repeatedly.

Note: For computers with hotkey mode enabled, press Fn + F2.

Change the startup sequence

You may need to change the startup sequence to allow the computer to start from another device or a

network location.

Step 1.

Open the UEFI/BIOS setup utility.

Step 2.

Navigate to the Boot menu.

Step 3.

Follow on-screen instructions to change the order of devices under Boot Priority Order.

Note: You can also change startup sequence temporarily without opening the setup utility. To do so, start

the computer. When the Lenovo logo appears, press F12 (or Fn + F12) repeatedly.

Change hotkey mode

Step 1.

Open the UEFI/BIOS setup utility.

Step 2.

Select Configuration ➙ Hotkey Mode and press Enter.

Step 3.

Change the setting to Disabled or Enabled.

Step 4.

Select Exit ➙ Exit Saving Changes.

Enable or disable always-on

For some Lenovo computers with always-on connectors, the always-on function can be enabled or disabled

in the UEFI/BIOS setup utility.

Step 1.

Open the UEFI/BIOS setup utility.

Step 2.

Select Configuration ➙ Always On USB and press Enter.

Step 3.

Change the setting to Disabled or Enabled.

Step 4.

Select Exit ➙ Exit Saving Changes.

Chapter 3

Explore your computer