Nikon 2100 - Coolpix Digital Camera 빠른 시작 매뉴얼 - 페이지 3

{카테고리_이름} Nikon 2100 - Coolpix Digital Camera에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Nikon 2100 - Coolpix Digital Camera 7 페이지.

Untitled Document

Copy the firmware to the memory card

The firmware can be copied to the camera memory card either by connecting the computer directly to

the Coolpix 2100 using the USB cable, or by removing the memory card from the camera and inserting it

in a CompactFlash card reader.

Direct USB Connection

Turn the camera off and insert the formatted memory card into the Coolpix 2100.

For information on formatting memory cards, see the Nikon

Guide to Digital

Photography with the

Coolpix 2100

Set the USB option in the camera setup menu to Mass Storage.

For information on the USB option and connecting the camera to a computer, see the

Nikon Guide to Digital

Photography with the

Coolpix2100

Turn the camera off and connect the USB cable as shown below.

UC-E6 USB cable

Rotate the mode dial to (auto) or (manual) and turn the camera on.

If Nikon View has been installed on the computer, Nikon Transfer will start automatically and

display the message, "There is no selected transfer image in the camera or on the card." Click

OK to exit Nikon Transfer.

Copy the firmware to the memory card.

file:///K|/2100fwMAC.html (3 of 7) [6/22/2010 12:02:59 PM]

Copy the firmware to the untitled volume corresponding to the camera.

When the camera is connected and turned on, an untitled volume will appear on the

desktop. Copy the "firmware" folder from the "CP2100fw11" folder to this untitled volume.

Be sure to copy the "firmware" folder and not just the ".bin" file.Copy it to the top directory

of the card, just drag the "firmware" folder to the "NO_NAME" (OS X) or "UNTITLED" (OS (8

or 9) disk.