Nikon TIRF 사용 설명서 - 페이지 8
{카테고리_이름} Nikon TIRF에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Nikon TIRF 37 페이지. System for te2000
페이지 인쇄9. Power supply ratings and power supply cords
Check the AC adapter for the shutter control unit
The shutter control unit is powered by the AC adapter. Be sure to use specific adapter model
meeting the requirements below. Use of any other type of adapter can result in malfunction,
excessive heating, and/or fire.
• To prevent malfunction and/or fire, be sure to use the AC adapter in a well-ventilated
location. To ensure that it radiates heat properly and does not overheat, never cover or
place any object on the adapter.
• To prevent malfunction, always turn off the power switch (switch to "O") of the shutter
control unit before attaching the AC adapter.
Specified AC adapter
Manufacturer:
Model:
Rated input voltage: AC 100-240 V, 0.7 A, 50/60 Hz
Rated output voltage: DC 12 V
Rated output current: 2.5 A
Others:
Power cord for AC adapter
To prevent electric shock, always turn off the power switch (switch to "O") for the shutter control
unit before attaching or detaching the power cord. Use one of the power cords specifies below.
Use of an improper power cord can result in fire or other hazard.
• Using units in areas where the supply voltage is 100 to 120 V
UL listed detachable power cord set,
3 conductor grounding Type SVT, No.18AWG, 3 m long maximum, rated at 125 V AC
minimum.
• Using units in area where the supply voltage is 220 to 240 V
Approved according to EU/EN standards,
3 conductor grounding Type HO5VV-F, 3 m long maximum, rated at 250 V AC minimum.
10. Cable connections
Always switch off the power switches to all equipment before connecting or disconnecting cables.
To prevent broken wires, do not pull cables by the sheath; instead, firmly grasp the plug when
connecting or disconnecting a cable.
11. Response if the system operates abnormally
If you discover that the system is not functioning properly, switch off all power switches, and
disconnect power cords from the outlets.
12. Prevent contact with moisture
Water splashed onto any component of the system may cause short circuits, resulting in
malfunction. If a piece of equipment is subject to contact with water, immediately switch off the
power switch to that piece of equipment and wipe off the water with a dry cloth. If water enters a
component, immediately suspend use of the system, disconnect the power cord from the outlet,
and contact your nearest Nikon representative.
Safety Precautions (Read the following before use!)
PHIHONG ENTERPRISE (Taiwan)
PSA-30U-120 (N)
UL-recognized product, GS-approved product，CE-satisfied product
- 6 -