Nikon D90 - Digital Camera SLR 사용자 설명서 - 페이지 13

{카테고리_이름} Nikon D90 - Digital Camera SLR에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Nikon D90 - Digital Camera SLR 26 페이지. Focal digital camera
Nikon D90 - Digital Camera SLR에 대해서도 마찬가지입니다: 브로셔 및 사양 (9 페이지), 운영 매뉴얼 (20 페이지), 사양 (2 페이지), 체크리스트 및 운영 매뉴얼 (25 페이지), 매뉴얼 (28 페이지), 방법 (6 페이지), 매뉴얼 (30 페이지)

페이지 인쇄

1. Techical Information

Battery

The HugyCheck system runs on a single CR123A 3V battery.

Please make sure to install this battery correctly as a reversed polarity will

damage the circuitry. Do not use batteries with a voltage higher than 3 Volt

as this will damage the electronics.

Strobe switchboard

The HugyCheck system is developed to allow all possible combinations be-

tween camera and external strobes. Given the amount of possible combina-

tions and settings, we advise you to read this section carefully.

SW1

Hugyfot Housing for

The camera hot shoe cable can be connected

to either J1 (direct) or J2 (converter) on the cir-

cuit board. The J2 connecter is only to be used

when the optional TTL converter is installed.

When no TTL converter is installed inside the

housing and the camera hot shoe is connected

to J2, the strobes won't fire.

The J1 connecter is used when strobes are used

in manual mode or when strobes are used that

are fully iTTL or eTTL compatible (e.g. Nikon

SB 800, Canon 580 EX, Subtronic dttl, ...)

Next to J1 is a switchboard SW1 which contains

6 switches (3 for each strobe) which control the

Q, the SP and the Ready signal on both exter-

nal strobe connections. By using these switch-

es one can individually control the Q, the SP

and the Ready signal on each strobe connec-

tion. The X and the Ground signal (as well as

the 6th Canon line in case of Canon hou sings)

are permanently wired through and cannot be

switched off.

Nikon D90

User manual