Nikon DS-5MC 사용 설명서 - 페이지 4
{카테고리_이름} Nikon DS-5MC에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Nikon DS-5MC 47 페이지. Ds camera control unit, ds camera head, ds cooled camera head
Nikon DS-5MC에 대해서도 마찬가지입니다: 사용 설명서 (49 페이지), 빠른 참조 (15 페이지)
페이지 인쇄
1. Using the equipment
This equipment should be used for photographic purposes only. Do not attempt to use it for any other
purpose.
2. Do not disassemble or repair the equipment.
The DS-U1 contains high-voltage power supply. Never attempt to disassemble or repair the equipment
by yourself; doing so may result in electric shock or equipment failure. Never attempt to disassemble
any part of the equipment unless instructed to do so in this manual. If you notice any problems with
the equipment, turn off the power and contact your nearest Nikon representative.
3. Power cord
To prevent electric shock, always turn off the POWER switch on the DS-U1 when plugging in or
unplugging the power cord. For the DS-U1, use only the specified power cord. The specifications for the
specified power cord are given below. Using another power cord may lead to fire or other hazardous
conditions.
Because this equipment falls under the category of electric shock protection class I, always make sure
it is grounded to a protective ground terminal. If you misplace or damage the power cord, contact your
nearest Nikon representative.
• When using the product in 100-120 V AC regions:
Use an UL-listed detachable power cord set.
3 conductor grounding Type SVT. No.18 AWG, 3m long maximum, rated at 125V AC minimum
• When using the product in 220-240 V AC regions:
Use only an EU/EN-approved three-conductor power cord set.
3 conductor grounding Type H05VV-F, 3m long maximum, rated at 250V AC minimum
4. Handling
•
To prevent malfunctions or overheating due to short circuits, do not allow this equipment or any
other device used with it to become wet. Never insert any foreign objects or materials into the
equipment. If the equipment gets wet, or if foreign matter (e.g., a scrap of paper) gets inside the
equipment, turn off the DS-U1's POWER switch and unplug the power cord from the outlet. Then
contact your nearest Nikon representative.
•
Do not bend or twist the cables with undue force. Doing so may damage the cables and result in
fire.
•
Do not place a cloth or paper on the DS-U1. Doing so may cause heat to collect inside the equipment,
resulting in fire.
- ii -