Nikon DS-Vi1 사용 설명서 - 페이지 19

{카테고리_이름} Nikon DS-Vi1에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Nikon DS-Vi1 49 페이지. Ds camera control unit/camera heads

Installing the DS-U3

The DS-U3 can be installed horizontally or vertically.

• Horizontal installation

Set the DS-U3 horizontally on a flat surface.

Provide a clearance of approximately 100 mm around the product to release heat.

• Vertical installation

Attach the vertical stand to the DS-U3 for setting the product in the vertical position.

Set the DS-U3 vertically on a flat surface as shown below.

Provide a clearance of approximately 100 mm around the product to release heat.

Attach the vertical stand as follows:

Remove two of the four screws at the upper front position and the lower rear position on the right

side of the DS-U3. (See Figure A below.)

Then, fix the stand to the right surface of the DS-U3 using the screws that have been removed.

(See Figure B below.)

Use an M2.5-size Phillips driver to attach or remove screws.

Chapter 4

Connecting and Installing the Equipment

Installing the DS-U3

Figure A

- 11 -

Figure B