Nikon Eclipse E600 사용 설명서 - 페이지 29

{카테고리_이름} Nikon Eclipse E600에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Nikon Eclipse E600 37 페이지. Teaching head/multi teaching head
Nikon Eclipse E600에 대해서도 마찬가지입니다: 사용 설명서 (38 페이지), 사용 설명서 (37 페이지), 사용 설명서 (21 페이지)

페이지 인쇄

Revolving

nosepiece assembly

LgŽLg„LÉLg2K„2="Yx2„».—

Revolving nosepiece installation

Use a hexagonal screwdriver to loosen the revolving nosepiece clamp screw.

Fit the revolv-

ing nosepiece into the revolving nosepiece mount on the microscope from the bottom and

slide it toward the rear of the microscope as far as it will go.

Tighten the clamp screw to

secure the revolving nosepiece.

Note on removing the revolving nosepiece

First, remove all the objectives.

Lower the stage completely, and hold the revolving nose-

piece in your hand so that it does not fall when you remove it.

Objective installation

Lower the stage completely.

Screw the objective into the revolving nosepiece so that the

magnification increases when the nosepiece is rotated in the clockwise direction when look-

ing down on the nosepiece from above.

Note on removing objectives

If there is a specimen on the stage, remove it first. Lower the stage completely, and hold each

objective in both hands so that they do not fall when you remove them.

| 5. Eyepiece tube assembly MM

Eyepiece tube installation

Loosen the eyepiece tube clamp screw. Tilt and insert the round dovetail on the eyepiece tube

into the round dovetail mount on the microscope arm.

Then tighten the eyepiece tube clamp

screw to secure the eyepiece tube in place.

2 Eyepiece installation

Install the left and right eyepieces, both with the same magnification.

There are positioning protrusions on the right sleeve. Align the notches of an eyepiece with

the protrusions on the sleeve and slide the eyepiece on. Some types of eyepiece tube do not

have such protrusions.

Fit the rubber eyeguard (sold separately) into the groove around the eyepiece.