Nikon Prostaff 7i 사용 설명서 - 페이지 6

{카테고리_이름} Nikon Prostaff 7i에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Nikon Prostaff 7i 33 페이지.

페이지 인쇄

5. Internal display

Horizontal Distance display mode

First Target Priority mode

Distant Target Priority mode

: Aim at the target you want to measure. Position the target at the center of the reticle.

: Appears while the laser is being irradiated for a measurement.

Do not look towards the objective lens side while this mark is shown.

: "Failure to measure" or "Unable to measure"

* Because the internal display of this product is enlarged by the eyepiece, dust may sometimes be seen.

This will not, however, affect the measurement accuracy.

6. Distance display units

Measurement results are displayed in yards/meters. (Factory default setting is yard.)

Yard

[

]

Meter

[

1. Turn on the power.

2. Press and hold the MODE button for more than two seconds. After the display unit has switched, release the button.

Distance

Unit of measure (m/yd.)

Target mark

Laser irradiation mark

Battery condition

]

7. Measurement display mode

Horizontal Distance

Horizontal

Mode

Distance

Actual Distance

Actual

Mode

Distance

8. Target priority mode

This Nikon Laser Rangefinder employs the First Target

Priority/Distant Target Priority switching system.

(Factory default setting is Distant Target Priority mode)

1. Turn on the power.

2. Press and hold the MODE button, then press and hold the POWER ON/Measurement button.

Continue to press and hold both buttons (for more than 2 seconds) until Target Priority modes are switched.

3. Release both buttons after the mode has switched.

* If the buttons are not pressed in the correct order, switching will not take place.

[First Target Priority mode/Distant Target Priority mode]

When measuring overlapping subjects, First Target Priority mode displays the distance of the closest subject and

Distant Target Priority mode displays that of the farthest subject.

1. Turn on the power.

2. Press and hold the MODE button, then

immediately press the POWER ON/Measurement

button.

3. Release your finger from the POWER ON/

Measurement button within 2 seconds to switch

the Measurement display mode.

4. Repeat steps 2 and 3 to switch measurement

display mode in rotation.

* If the buttons are not pressed in the correct order,

switching will not take place.

Distant Target Priority mode

First Target Priority mode

[

]

[

]