Nikon StabilEes 14x40 사용 설명서 - 페이지 10

{카테고리_이름} Nikon StabilEes 14x40에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Nikon StabilEes 14x40 34 페이지.

페이지 인쇄

How to Use and Focus

1. If you wear glasses or sunglasses when

using binoculars, fold back the rubber eyecup

on each eyepiece (ocular lens) so you can view

complete images.

2. Next, grasp either eyepiece and rotate it

towards or away from the center of the

binocular (the other eyepiece will move equally

in the opposite direction.)

Adjust the interpupillary distance to match the

distance between your eyes until you see just

one perfectly round image.

3. There are two steps to focusing: Close your

right eye and use only your left eye as you

adjust the focus control knob (3). When the

image is sharp, close your left eye and open

your right eye. Twist the right eyepiece, to

focus for the right eye. Now open both eyes

and the binocular should be perfectly focused.

You can do this with the StabliEyes turned on

with stabilizing activated or with the power off

completely.

4. The StabilEyes power on/off sequence is

simple. Pressing the POWER ON button (1) the

first time activates an internal system check,

causing the LED I (located between the two

eyepieces) to glow orange. Pressing the

POWER ON button a second time activates

stabilization, and the LED I turns green.

The stabilization mode default is set for LAND

mode (LED II: green). Pressing the MODE

button changes it to ON BOARD mode (LED II:

orange). Pressing the MODE button causes

StabilEyes to switch modes, from ON BOARD

to LAND, or vice versa. Simply select the

stabilization mode that best suits your viewing

situation.

If you press the same button a third time, the

StabilEyes goes on standby (orange LED I

again). Press it again, stabilization is

reactivated. You may repeat this process as

often as you wish. Reverting to standby

conserves battery power. On the other hand, if

you leave the StabilEyes in either standby or

stabilization mode for about three minutes

without using it, it will shut itself off

automatically.

Operating System of StabilEyes

* Turning the power off automatically resets the vibration reduction mode to "Land" mode.

Press the

ON button

Power on

The system powers up

LED I

and performs a

orange

5-second system check

If StabilEyes is left in standby or stabilization mode for about three

minutes without using, it automatically shuts off.

Press the

ON button

LED I

Stabilization is

in standby

orange

Pressing the ON button causes StabilEyes

to switch from Standby to Active, or vice versa.

Press the

MODE button

LED II

ON BOARD

mode

orange

Pressing the MODE button causes StabilEyes

to switch modes, from ON BOARD to LAND, or vice versa.

Press the

OFF button

Power off

LED I•II

Stabilization is

turned off

off

LED I

Stabilization

activated

green

LED II

LAND mode

green