Cub RV BLIND SPOT 설치 매뉴얼 - 페이지 7

{카테고리_이름} Cub RV BLIND SPOT에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cub RV BLIND SPOT 12 페이지. Detection system

5. INSTALLATION

3. SYSTEM LAYOUT

5.3 INSTALLATION

1. The BSD sensors will be installed to sides of the motorhome.

2. Locate an installation area between 29 - 41 inches from the ground and mark

height line with painter's tape.

3. Locate the radar within 8 inches from the rear of the motorhome that is parallel to lane

markings.

4. Level the sensor to be parallel to the ground.

5. You may have to remove panels and covers to install the sensors.

6. Use the Radar Mounting Gasket as a template to pre-drill the installation holes.

7. Use qualified hardware to affix the sensor.

8. Connect harnesses and electrical connections.

9. Secure all harnesses using cable ties.

10. Route harness assembly from the sensors to your engine bay grommet to pass the

harness into the cabin. Secure the harness away from the heat sources and moving

parts. Affix it to the vehicle using cable ties. You may skip this step and the next if the

harness is run inside the coach.

RV BLIND SPOT DETECTION SYSTEM: For Motorhomes | 5