Dirt Devil LET'S GO. DDW02-R01 사용자 설명서 - 페이지 16

{카테고리_이름} Dirt Devil LET'S GO. DDW02-R01에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dirt Devil LET'S GO. DDW02-R01 20 페이지.

REmOvE AND REPlACE THE BElT

OR BRUSHBAR

1. Remove the dirty water

and clean water tank.

Switch off and unplug

the carpet washer. Flip

the cleaner on it's side to

expose the nozzle base.

To remove the belt cover,

use a phillips screwdriver

to remove the two screws.

4. Lift brushbar while

pulling it out.

2. Hold the belt cover near

the belt roll and lift out.

5. Slide the belt off the the

motor shaft and dispose.

When replacing the belt,

first slide it onto the

motor shaft. Then slip

the brushbar through the

belt. Place the belt in the

area of the brush without

bristles.

Slide the brushbar into the

nozzle, ensuring that the

brushbar end caps line up

correctly.

CaUTiOn

Don't over saturate your upholstery.

3. Grasp the brushbar with

one hand, using the other

hand to keep tension

on the the belt while

removing.

Manually turn the brushbar

to check that it is fitted

properly.

Replace the belt cover by

inserting the end furthest

from the brush first. Then

replace the front of the

belt cover before securing

in place with the two

screws.