Clas Ohlson TN-8019 빠른 시작 매뉴얼
{카테고리_이름} Clas Ohlson TN-8019에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clas Ohlson TN-8019 5 페이지. Bubble solar garden lights
페이지 인쇄
Bubble Solar Garden Lights
Art.no 36-6978
Model TN-8019
Please read the entire instruction manual before use and
then save it for future reference. We reserve the right for any
errors in text or images and any necessary changes made
to technical data. In the event of technical problems or other
queries, please contact our Customer Services.
Safety
Important
•
Handle the product with care, making sure not to damage
the surface of the solar cell and ensuring that it is not
covered with dust or affected by other contaminants.
•
Never attempt to repair or modify the product in any way.
•
Repairs must only be carried out by authorised service
personnel and only using genuine spare parts.
•
The battery must only be replaced with a rechargeable battery.
•
Never let children play with the product.
Information
The lights can also be
powered by a battery
pack or a mains adaptor
(both sold separately) to
enable them to be used
all year round. Disconnect
the solar cell and replace it
with either a battery pack or
mains adaptor.
Assembly
Information
When placing the product outdoors, make sure that it has
access to maximum sunlight and is not affected by other light
sources such as street lights.
GREAT BRITAIN • customer service tel: 020 8247 9300 e-mail [email protected] internet www.clasohlson.co.uk postal 10 – 13 Market Place, Kingston Upon Thames, Surrey, KT1 1JZ
Solar cell
Placed on a ground spike
1. Attach the ground spike
2. Adjust the angle of
to the solar cell bracket
the solar cell to receive
and then push the spike
as much sunlight as
into the ground.
possible.
Fastened to a structure such as a wall
1. Remove the nuts/bolts on
the bracket on the back of
the solar cell.
2. Using the bracket as a guide,
mark out the position of
the mounting holes on the wall.
3. Use an appropriate type of screw
for the wall material and attach
the bracket to the wall.
Important: Make sure that
there are no electrical wires or water pipes in the wall where
you intend to drill/screw.
4. Screw the solar cell onto the bracket.
5. Adjust the angle of the solar cell so that it receives as much
sunlight as possible.
Instructions for use
1. Push the 5 lamps into
the ground.
2. Connect the lamps and
the solar cell's plugs.
3. Set the switch on the back of the solar cell to W for a fixed
white light or to RGB for sweeping RGB colours.
4. The lights will come on automatically at dusk.
Care and maintenance
•
Clean the product using a slightly damp cloth. Use only mild
cleaning agents, never solvents or corrosive chemicals.
•
Replacing the battery, when required:
1. Remove the 4 screws
2. Change the battery and
on the back of
make sure that it is inserted
the solar cell.
with the correct polarity.
Troubleshooting
What to do if the lights do not shine.
•
Check that the power switch is in the W or RGB position.
•
The battery is discharged. Make sure the solar cell is
exposed to sunlight.
•
The solar cell is dirty. Clean it by wiping with a damp cloth.
Responsible disposal
This symbol indicates that this product should not
be disposed of with general household waste.
This applies throughout the entire EU. In order
to prevent any harm to the environment or
health hazards caused by incorrect waste
disposal, the product must be handed in for
recycling so that the material can be disposed
of in a responsible manner. When recycling
the product, take it to your local collection facility or contact
the place of purchase. They will ensure that the product is
disposed of in an environmentally sound manner.
Specifications
1 × AA/HR06 NiMH 600 mAh
Rechargeable battery
Charging time
8 hours (in continuous sunlight)
Operating time
8 hours (when fully charged)
Height above ground
58 cm