ABB REX 521 운영 매뉴얼 - 페이지 14

{카테고리_이름} ABB REX 521에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ABB REX 521 20 페이지. Relay retrofit program, cutting tool

Vent lever

C u t t i n g To o l O p e r at i n g G u i d e

1 4

3. Start the cutting procedure by pushing the

guiding faces of the cutting head to the cut-out

edges: to the top edge and to the right edge

side if the right edge widening/cutting is valid.

For your safety, keep your hands on the power

unit, never on the cutting head.

Beware of the sharp edges!

4. Push the operating switch as long as the sheet

metal part has been cut off.

Be careful with the flinging offcuts, especially

if the offcut gatherer is not used.

Do not push the operating switch too long as

it may cause maximum pressure in the power

unit and result in additional force with vent

lever use.

5. Push the vent lever to ensure that the punch is

released after each cut.

In some cases, additional force is needed to

push the vent lever.

6. Make five cuts 1...5/6...10 one below the other (see

figure 4).

Shake the cutting tool in between the cuttings

1...10 to arrange more space for the offcuts

inside the gatherer.

It is recommended to make overlapping cuts of 1...3

mm to avoid sharp edges in between the cutting

junction points.