Dirt Devil UP04 사용자 설명서 - 페이지 14

{카테고리_이름} Dirt Devil UP04에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dirt Devil UP04 20 페이지. Lightweight pet upright

MAINTENANCE

• Do not clean the vacuum cleaner, components or accessories using

MAINTAINING YOUR VACUUM

petrol or any other ﬂammable liquid or solvents, etc.

• Clean only the outside of the vacuum cleaner.

CLEANER

• Use only a moist cloth and mild detergent for cleaning the vacuum

cleaner, components and accessories.

and accessories with a dry cloth.

• Do not place accessories, tools or components in a dishwasher.

Bush Roll

MAINTAINING THE BRUSH ROLL

You should check your cleaner's brush roll and drive belt regularly for

wear or damage. You should also clean the brush and brush ends by

removing string, hair and carpet ﬁbres. These can wrap around the

You should check your cleaner's brush roll and drive belt regularly for wear or damage. You should also clean

the brush and brush ends by removing string, hair and carpet fibres. These can wrap around the brush and

remove any debris that has accumulated under the brush cover.

hamper its ability to effectively clean your carpet. Also remove any debris that has accumulated under the

vacuum and unplug from electrical outlet.

brush cover.

Place vacuum upside down with brush roll facing upwards.

1. Turn off the vacuum and unplug from the electrical socket.

Remove the six screws as shown with a small Phillips screwdriver

2. Place the vacuum upside down with brush roll facing upwards.

(see image 1).

Lift off brush cover(see image 2).

3. Remove the six screws as shown with a small Phillips screwdriver (see figure 1).

4. Lift off brush cover (see figure 2). It will unclip from the securing lug on the front of the housing.

Grasp ﬂoor brush at both ends and remove by lifting out(see image 3).

5. Grasp floor brush at both ends and remove by lifting out (see figure 3).

Clean string, hair and other debris from ﬂoor brush, motor pulley, and

drive belt(see image 4).

6. Clean string, hair and other debris from floor brush, motor pulley, and drive belt (see figure 4).

Check air passageway for obstructions. Remove debris from this area.

7. Check air passageway for obstructions. Remove debris from this area. When finished cleaning, reposition

When ﬁnished cleaning, reposition ﬂoor brush and drive belt. Turn

floor brush and drive belt. Turn floor brush by hand several times in the direction of the motor pulley. If

ﬂoor brush by hand several times in the direction of the motor pulley.

properly installed, the drive belt will align itself on floor brush. Then replace the brush cover and re-install the

six screws (see figure 5)

If properly installed, the drive belt will align itself on ﬂoor brush. Then

replace the brush cover and re-install the six screws （see image 5)

Remove

Six Screws

DIRTDEVIL.CO.UK