Dirt Devil Vacuum Cleaner 소유자 매뉴얼 - 페이지 7
{카테고리_이름} Dirt Devil Vacuum Cleaner에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dirt Devil Vacuum Cleaner 8 페이지. Vacuum cleaner dirt devil
Dirt Devil Vacuum Cleaner에 대해서도 마찬가지입니다: 소유자 매뉴얼 (10 페이지), 소유자 매뉴얼 (8 페이지), 소유자 매뉴얼 (18 페이지), 소유자 매뉴얼 (18 페이지), 소유자 매뉴얼 (18 페이지), 소유자 매뉴얼 (18 페이지), 소유자 매뉴얼 (14 페이지)
페이지 인쇄
For additional filtration, a HEPA media exhaust filter i s located below the dirt cup. For best performance, replace filter yearly.
TOOL REQUIRED: PHILLIPS SCREWDRIVER
*HEPA filter part # 3-860057-000, is located below the dirt container.
*MiiFresh
"
filter part# 586009(M00, is located below the dirt container.
NOTE: Unplug cleaner befote changing filter.
NOTE: For best performance, replace filter yearly.
For *MicroFreshm and "HEPA filter replacements call 1-800-321-1134 (USA & Canada).
Remove dirt container. To
remove the filter aver lid, use
a Phillios screwdriver to
remove ; h e (I) screw.
*Not available on all models
*HEPA FILTER
Pull filter cover lid up and
away from cleaner.
Grasp HEPA filter cartridge
and pull out. IMPORTANT: Do
NOT clean wifh water.
To replace: Insert HEPA filter
into housing. Replace screw
filter cover.
"MICROFRESH" FILTER
Grasp MimFresh
"
filter and
pull out. IMPORTANT: Do NOT
clean wifh water. To replace:
Insert MimFresh
"
filter into the
channel of
the
housing.
Replace filter cover and screw.
TOOL REQUIRED: PHILLIPS SCREWDRIVER
WARNING: TO REDUCE THE RISK OF INJURY FROM MOVING PARTS
-
UNPLUG CLEANER BEFORE CHANGING BELT OR BRUSHROLL.
BELT STORAGE: Stretch belt around hooks on back panel of upright (see page 4, figure 2 for belt storage location).
BELT STYLE: 4 & 5
Flip cleaner to expose base.
Flip cleaner back over and l i
Lift
and remove blushroll.
Base should lay flat and face
nozzle wver off. Slide belt off
Dispose of old belt.
up. To remove nozzle cover,
motor shaft.
use Phillips screwdriver to
remove the four (4) screws.
Arrows show location of
screws.
Place belt on motor shaft, then
slip brushroll through belt.
Place belt in area of brushroll
without bristles. W i belt in
place, pull and slide brushroll
into nonle making sure that
the blushroll end caps are in
the
w d
orientation,
IMPORTANT: Rotate brushroll
manually to make sure belt is
not twisted. Reattach nonle
cover. Secure by p lacing the
screws under the nozzle base.