Dirt Devil UD70187 사용자 설명서 - 페이지 3
{카테고리_이름} Dirt Devil UD70187에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dirt Devil UD70187 13 페이지.
페이지 인쇄
TOOLS
EXTENSION WAND: Attach to cleaning wand for
longer reach on above and hard floor cleaning.
*
TURBO TOOL
: For upholstered furniture,
®
draperies, mattresses and stairs.
*Accessories not included on all models.
ABOVE FLOOR CLEANING
CAUTION:
Use extra care when
cleaning on stairs. To avoid personal injury or
damage, and to prevent the cleaner from falling,
always place cleaner at bottom of stairs or on
floor. Do not place cleaner on stairs or furniture,
as it may result in injury or damage. When
using tools, always ensure handle is in upright
position.
1
Remove Quick Release Cleaning Handle Wand for
convenient above floor cleaning.
2
Insert hose into handle wand.
3
Attach extension wand and 2-in-1 tool for
improved cleaning.
*Accessories not included on all models.
HOW TO
WARNING:
To reduce the risk of
personal injury - Unplug before cleaning or
servicing. Do not use vacuum without dirt cup
or filters in place.
EMPTY THE DIRT CUP
A
1
Push the release button (A) then pull out the
dirt cup.
B
2
Now ditch the dirt by pushing the lower button
(B). Give it a wipe to remove dust.
3
Place back in bottom first. Push the top of the cup
against the back panel, and it'll click into place.
CLEAN THE RINSABLE FILTER AND
CYCLONIC ASSEMBLY
1
Remove the dirt cup. Twist the handle to remove
the top from the dirt cup. Gently remove the filter
from the the handle.
2
Tap clean into a trashcan.
3
All pieces are rinsable. Allow to dry 24 hours
before using.
4
Next pull cyclonic assembly out of the dirt cup.
5
Use the Dusting Tool to clean the cyclonic
assembly.*
6
When reassembling, ensure the cyclonic
assembly is aligned and twist the lid into the
locked position.
CLEAN THE EXHAUST FILTER*
1
Push the tab on the front of the cover to pivot out.
2
Pull out the filter, rinse dirt from both sides, and let
air dry for 24 hours before reinstalling or until dry.
3
Put the dry filter back. Now line up the filter cover
with the bottom tabs first and then snap back
into place.
*Not all models have this feature
CLEAN THE BRUSHROLL
1
Turn your vacuum over. Use a Phillips screwdriver
to take off the 6 screws. Remove the bottom plate.
2
Clean the brushroll.
3
Slide on belt with the lettering on the outside.
REPLACE THE BELT
CAUTION:
To reduce the risk of injury
from moving parts - Unplug before servicing.
1
Turn your vacuum over. Use a Phillips screwdriver
to take off the 6 screws. Remove the bottom plate.
2
Then take off that old belt. Slide on a new belt
with the lettering on the outside.